- Store vehicles in your garage
- Get product recommendations
- Easily find products and accessories
50W Lighting Stator for KTM 250 SX-F | 400 SX | 450 SMR SXS XC | 520 525 SX | Husaberg FC 550 450 2000-2010 77039004000
50W Lighting Stator for KTM 250 SX-F | 400 SX | 450 SMR SXS XC | 520 525 SX | Husaberg FC 550 450 2000-2010 77039004000
Please note : We suggest using a 35W halogen bulb in the headlight with a 12V AC regulator, which will ensure a good lighting output at most RPMs you will be running your KTM at.
Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !

Details
Details
Brand new aftermarket 50W lighting stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- Rubber grommet included
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause for repetitive electrical issues.
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Specifications
Specifications
Dimensions :
Interior diameter : 28 mm
Exterior diameter :58 mm
Thickness : 28 mm
Length of wires stator to grommet : 130 mm
Length of wires grommet to plug : 400 mm
Other specifications :
Number of wires : 3
Number of plugs : 2
Number of pins : 3
Number of poles : 6
Wire to wire resistance :
Alternator : Black/Red to White/Red = 0.02 ohms +-20%
Alternator to ground = O.L
Interchange Part Nº
Interchange Part Nº
- 80039004100
- 77039004000
- 59039004000
Installation
Installation
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulatorrectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Warning:
Risk of electric shock. Disconnect the battery before servicing.
Ensure proper installation by a qualified technician to avoid malfunction.
Vehicle Fitments
Vehicle Fitments
Let customers speak for us
Our customers are our most important asset, we are here to help you in real time! Call us now, or connect with a specialist via email.
