- Store vehicles in your garage
- Get product recommendations
- Easily find products and accessories
Generator Stator for Honda PC 800 Pacific Coast 1989 OEM Repl.# 31120-MR5-015 31120-MR5-005
Generator Stator for Honda PC 800 Pacific Coast 1989 OEM Repl.# 31120-MR5-015 31120-MR5-005
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Details
Details
Brand new stator
- You must re-install your original grommet and the new connector (see picture).
- Once your connector and grommet is re-installed, our part becomes a Plug-and-play unit, direct fit, and very easy to install.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- All product shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Specifications
Specifications
Dimensions:
Interior diameter: 53 mm
Exterior diameter: 114 mm
Thickness: 26 mm
Length of wires stator to plug: 1180 mm
Other specifications:
Number of wires: 3
Number of plugs: 0
Number of pins: 3
Number of poles: 18
Wire to wire resistance:
Alternator: Yellow to Yellow = 0.6 ohms +/-20%
Alternator: Yellow to ground = O.L
Interchange Part Nº
Interchange Part Nº
- 31120-MR5-005
- 31120-MR5-015
Installation
Installation
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Warning:
Risk of electric shock. Disconnect the battery before servicing.
Ensure proper installation by a qualified technician to avoid malfunction.
Vehicle Fitments
Vehicle Fitments
Let customers speak for us
Our customers are our most important asset, we are here to help you in real time! Call us now, or connect with a specialist via email.
