Menu

Canada Client canadien ?  Allez au site canadien

X

Based on your location and your browser preferences, we suggest the following regional preferences:

English, Worldwide

Service à la clientèle 1-877-838-1399 - 8h-17h HNE Lun-Jeu & 8h-16h HNE Ven

Panier

0 item (0,00 US$)

X

Vous recherchez présentement avec des filtres

Used - Stator

RM01228U
RMSTATOR

Used - Stator

RM01228U
RMSTATOR

Disponibilité : Rupture de stock

Prix : 99,50 US$

Direct Replacement Arctic-Cat Stator

  • Direct replacement to your original unit, plug-and-play, direct fit, easy installation.
  • Highest grade lamination materials, highest grade copper windings, resistant to 200 degrees Celsius.
  • Connector included
  • All product shipped are tested
  • 30 days limited warranty

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Détails

Direct Replacement Arctic-Cat Stator

  • Direct replacement to your original unit, plug-and-play, direct fit, easy installation.
  • Highest grade lamination materials, highest grade copper windings, resistant to 200 degrees Celsius.
  • Connector included
  • All product shipped are tested
  • 30 days limited warranty

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Videos

Spécifications


Ten wires

Eleven terminals

ALTERNATOR Yellow to Yellow 1.6 ohms ±20%

FUEL PUMP Blue/White to Blue/White 18.5 ohms ±20%

SOURCE COIL 1 Green to Brown 10 ohms ±20%

SOURCE COIL 2 Green to Black 10 ohms ±20%

SOURCE COIL 1&2 Black to Brown 20 ohms ±20%

OTHER Orange to Orange 3.0 ohms ±20%



# Remplacement OEM


3007-693
3007-701
3007-447
3007-617


Instructions d'installation

Before installing your new stator

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.

Commentaires

Q&A