Menu

Canada Client canadien ?  Allez au site canadien

X

Based on your location and your browser preferences, we suggest the following regional preferences:

English, Worldwide

Service à la clientèle 1-877-838-1399 - 8h-17h HNE Lun-Jeu & 8h-16h HNE Ven

Panier

0 item (0,00 US$)

X

Vous recherchez présentement avec des filtres

Stator Haute Puissance Suzuki 1996-2013 ( DR 650 SE DR 650 SM )

RM01047
RMSTATOR

Stator Haute Puissance Suzuki 1996-2013 ( DR 650 SE DR 650 SM )

RM01047
RMSTATOR

Disponibilité : En stock

Prix : 169,00 US$

OU

Brand new Stator Haute Puissance

  • Direct replacement to your original unit
  • Pick up pulsar coil included
  • Connector included
  • Rubber grommet included
  • Highest grade lamination materials
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • All product shipped are tested
  • One year limited warranty

20% More output over stock, works with all other OEM components.

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Détails

Brand new Stator Haute Puissance

  • Direct replacement to your original unit
  • Pick up pulsar coil included
  • Connector included
  • Rubber grommet included
  • Highest grade lamination materials
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • All product shipped are tested
  • One year limited warranty

20% More output over stock, works with all other OEM components.

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Videos

# Remplacement OEM

32101-32E00

Compatibilité

Instructions d'installation

Salvage the OEM stator connector and 4 inches of wiring from the OEM harness.You will need to use a small soldering iron, solder the wires of the OEM wiring harness to the wires on your new stator, by following their color codes.

Before installing your new stator

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier.
  • Check and repair any melted wiring.  
  • Use hi-temp dielectric grease on all connectors
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.

Commentaires

Q&A