Menu

Worldwide Client international ?  Allez au site international

X

Based on your location and your browser preferences, we suggest the following regional preferences:

English, Worldwide

Service à la clientèle 1-877-838-1399 - 8h-17h HNE Lun-Jeu & 8h-16h HNE Ven

Panier

0 item (0,00 $CA)

X

Vous recherchez présentement avec des filtres

Used - Generator Stator

RM01063U
RMSTATOR

Used - Generator Stator

RM01063U
RMSTATOR

Disponibilité : Rupture de stock

Prix : 57,00 $CA

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation.
  • Pick up pulsar coil included
  • Connector included
  • Rubber grommet included
  • Highest grade lamination materials
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • All product shipped are tested
  • 30 Days limited warranty

 

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Détails

  • Direct replacement to your original unit
  • Plug-and-play, direct fit, easy installation.
  • Pick up pulsar coil included
  • Connector included
  • Rubber grommet included
  • Highest grade lamination materials
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • All product shipped are tested
  • 30 Days limited warranty

 

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Videos

Spécifications

Three wires

Three terminals

ALTERNATOR White Between each White 0.4 ohms ±20%

ALTERNATOR White to Ground O.L ON DISPLAY

PICK UP White to Black 190 ohms ±20%

 

# Remplacement OEM

21-411

Instructions d'installation

Before installing your new stator

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

 

Our stator may use a different wire color code then you’re original.

All of the wires are installed in the correct order; please do not change any of the wiring configurations.

This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.

If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.

Commentaires

Q&A