Stator for Ducati Superbike 749 & 999 R S 2003-07 | Superbike 1098 R S / 1198 S 2003-11 | Street fighter 1099 2009-2012
Please note : There are 2 possible stators for Ducati Multistrada 2003-2006. This stator has an outside diameter of 115 mm, an inner diameter of 54 mm and a stack height of 19 mm. The other possible stator is RMS010-103795.
Please compare your original unit to our pictures, before buying.
Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !
- 2013 Ducati 848 Super Bike
- 2013 Ducati 848 Street Fighter
- 2012 Ducati Street Fighter S 1099
- 2012 Ducati 848 Super Bike
- 2012 Ducati 848 Street Fighter
- 2011 Ducati Superbike 1198
- 2011 Ducati Street Fighter S 1099
- 2011 Ducati 848 Super Bike
- 2010 Ducati Superbike 1198
- 2010 Ducati Street Fighter S 1099
- 2010 Ducati 848 Super Bike
- 2009 Ducati Superbike 1198 S
- 2009 Ducati Superbike 1198
- 2009 Ducati Superbike 1098 R
- 2009 Ducati Street Fighter S 1099
- 2009 Ducati 848 Super Bike
- 2008 Ducati Superbike 1098 S
- 2008 Ducati Superbike 1098 R
- 2008 Ducati Superbike 1098
- 2008 Ducati 848 Super Bike
- 2007 Ducati Superbike 999
- 2007 Ducati Superbike 749
- 2007 Ducati Superbike 1098 S
- 2007 Ducati Superbike 1098
- 2006 Ducati Superbike 999 S
- 2006 Ducati Superbike 999 R
- 2006 Ducati Superbike 999
- 2006 Ducati Superbike 749 S
- 2006 Ducati Superbike 749 R
- 2006 Ducati Superbike 749
- 2005 Ducati Superbike 999 S
- 2005 Ducati Superbike 999 R
- 2005 Ducati Superbike 999
- 2005 Ducati Superbike 749 S
- 2005 Ducati Superbike 749 R
- 2005 Ducati Superbike 749
- 2004 Ducati Superbike 999 S
- 2004 Ducati Superbike 999 R
- 2004 Ducati Superbike 999
- 2004 Ducati Superbike 749 S
- 2004 Ducati Superbike 749 R
- 2004 Ducati Superbike 749
- 2003 Ducati Superbike 999 S
- 2003 Ducati Superbike 999 R
- 2003 Ducati Superbike 999
- 2003 Ducati Superbike 749
26420172A
Dimensions :
Interior diameter : 54 mm
Exterior diameter : 115 mm
Thickness : 19 mm
Length of wires stator to grommet : 140 mm
Length of wires grommet to plug : 190 mm
Other specifications :
Number of wires : 3
Number of plugs : 1
Number of pins : 3
Number of poles : 18
Wire to wire resistance :
Alternator : Between each Yellow = 0.4 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new aftermarket Stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Connectors included
- Rubber grommet included
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause of repetitive electrical issues.
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.