Stator for Honda CMX 250 Rebel 1996-2016
Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !
- 2016 Honda CMX 250 Rebel
- 2015 Honda CMX 250 Rebel
- 2014 Honda CMX 250 Rebel
- 2013 Honda CMX 250 Rebel
- 2012 Honda CMX 250 Rebel
- 2009 Honda CMX 250 Rebel
- 2008 Honda CMX 250 Rebel
- 2007 Honda CMX 250 Rebel
- 2006 Honda CMX 250 Rebel
- 2005 Honda CMX 250 Rebel
- 2004 Honda CMX 250 Rebel
- 2003 Honda CMX 250 Rebel
- 2002 Honda CMX 250 Rebel
- 2001 Honda CMX 250 Rebel
- 2000 Honda CMX 250 Rebel
- 1999 Honda CMX 250 Rebel
- 1997 Honda CMX 250 Rebel
- 1996 Honda CMX 250 Rebel
Dimensions :
Interior diameter : 35 mm
Exterior diameter : 93 mm
Thickness : 18 mm
Length of wires stator to grommet : 150 mm
Length of wires grommet to plug : 800 mm
Length of pickup coil's wire to grommet : 120 mm
Other specifications :
Number of wires : 6
Number of plugs : 2
Number of pins : 6
Wire to wire resistance :
Alternator : Between Each Yellow = 0.4 ohms +-20%
Pickup : Green/White to Blue/White = 125 ohms +-20%
Source : Black/Red to Ground = 200 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010''.
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause for repetitive electrical issues.
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.