Generator Stator for Honda VT 1100 Shadow / Spirit / Sabre / Aero / ACE 1987-2007
Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !
- 2007 Honda VT 1100 Shadow
- 2006 Honda VT 1100 Shadow
- 2005 Honda VT 1100 Shadow
- 2004 Honda VT 1100 Shadow
- 2003 Honda VT 1100 Shadow
- 2002 Honda VT 1100 Shadow
- 2001 Honda VT 1100 Shadow
- 2000 Honda VT 1100 Shadow
- 1999 Honda VT 1100 Shadow
- 1998 Honda VT 1100 Shadow
- 1997 Honda VT 1100 Shadow ACE
- 1997 Honda VT 1100 Shadow
- 1996 Honda VT 1100 Shadow ACE
- 1996 Honda VT 1100 Shadow
- 1995 Honda VT 1100 Shadow ACE
- 1995 Honda VT 1100 Shadow
- 1994 Honda VT 1100 Shadow
- 1993 Honda VT 1100 Shadow
- 1992 Honda VT 1100 Shadow
- 1990 Honda VT 1100 Shadow
- 1989 Honda VT 1100 Shadow
- 1988 Honda VT 1100 Shadow
- 1987 Honda VT 1100 Shadow
31120-MAH-005
31120-MAA-005
Dimensions :
Interior diameter : 54 mm
Exterior diameter : 115 mm
Thickness : 29 mm
Length of wires stator to grommet : 120 mm
Length of wires grommet to plug : 500 mm
Other specifications :
Number of wires : 3
Number of plugs : 1
Number of pins : 3
Wire to wire resistance :
Alternator : Between Each Yellow = 0.4 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010''.
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- Rubber grommet included
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause for repetitive electrical issues.
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.