Generator Stator for Polaris Genesis / FFI / I | MSX 140 | Virage I / TXI 1999-2004 | OEM Repl.# 4010320
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2004 Polaris Virage I
- 2004 Polaris MSX 140
- 2004 Polaris Genesis I
- 2003 Polaris Virage I
- 2003 Polaris MSX 140
- 2003 Polaris Genesis I
- 2002 Polaris Virage TXi
- 2002 Polaris Virage I
- 2002 Polaris Genesis I
- 2001 Polaris Virage TXi
- 2001 Polaris Genesis I
- 2000 Polaris Genesis FFI
- 1999 Polaris Genesis FFI
- 1999 Polaris Genesis
Dimensions :
Interior diameter : 54 mm
Exterior diameter : 127 mm
Thickness : 22 mm
Length of wires stator to grommet : 100 mm
Length of wires grommet to plug : 1800 mm
Other specifications :
Number of wires : 10
Number of plugs : 1
Number of poles : 12
Number of pins : 10
Wire to wire resistance :
Alternator 3p : Yellow/Green to Yellow/Gray = 1.2 ohms +-20%
Alternator : Yellow/Purple to Yellow/Black = 0.8 ohms +-20%
Alternator : Yellow/Blue to Yellow = 0.8 ohms +-20%
Alternator : Yellow/Black to Brown/Yellow = 0.9 ohms +-20%
Alternator : Brown/White to Brown = 0.9 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade of lamination materials
- Highest grade of copper winding, resistant to 200 degrees Celsius
- Connector included
- Rubber grommet included
- All products shipped are tested
All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part.