Canadian Customer?
0 item (US$0.00)
Brand new pick up coil for stator 300 ohms
- We offer a brand new pickup/pulsar coil for you to repair your stator.
- Often unavailable from the OEM manufacturer
- One year limited warranty
- All products shipped are tested
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Details
Brand new pick up coil for stator 300 ohms
- We offer a brand new pickup/pulsar coil for you to repair your stator.
- Often unavailable from the OEM manufacturer
- One year limited warranty
- All products shipped are tested
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Specifications
Dimensions:
Height: 22 mm
Length: 25 mm
Width: 23 mm
Bracket center to center: 35 mm
Wires length pickup coil to grommet: 25 mm
Wires length grommet to plug: 400 mm
Other specifications:
Number of wires : 2
Number of plugs: 1
Number of pins: 2
Wire to wire resistance:
Green/White to Blue/Yellow = 295 ohms +/-20%
Height: 22 mm
Length: 25 mm
Width: 23 mm
Bracket center to center: 35 mm
Wires length pickup coil to grommet: 25 mm
Wires length grommet to plug: 400 mm
Other specifications:
Number of wires : 2
Number of plugs: 1
Number of pins: 2
Wire to wire resistance:
Green/White to Blue/Yellow = 295 ohms +/-20%
OEM # Replacement
711265153
420265153
711265156
420265153
711265156
Fits models
- ATV
- 2007
- Can-am
- DS 650
- Can-am
- 2006
- Can-am
- DS 650
- Can-am
- 2005
- Can-am
- DS 650
- Can-am
- 2004
- Can-am
- DS 650
- Can-am
- 2003
- Can-am
- DS 650
- Can-am
- 2002
- Can-am
- DS 650
- DS 650 Baja
- Can-am
- 2001
- Can-am
- DS 650
- Can-am
- 2000
- Can-am
- DS 650
- Can-am
- 2007
Installation instructions
Not following these instructions may result in damaging the part or other components on your vehicle.
- By using a small soldering iron weld the wires to the ones on your OEM wiring harness.
- Insulate your solders with heat shrink.
- Before attempting to start your vehicle, adjusting the air gap is necessary for certain models.
- Rotate the flywheel by hand so the raised node is lined up with the pick up /pulsar coil and adjust as close as possible, but no less than 0.010’’.
- If no spark or erratic spark, switch the wires at the plug.