Kit Stator + Pickup Pulsar Coil for Suzuki RM 125 RM 250 1994-2001

• 2001 Suzuki RM 250
• 2001 Suzuki RM 125
• 2000 Suzuki RM 250
• 2000 Suzuki RM 125
• 1999 Suzuki RM 250
• 1999 Suzuki RM 125
• 1998 Suzuki RM 250
• 1998 Suzuki RM 125
• 1997 Suzuki RM 250
• 1997 Suzuki RM 125
• 1996 Suzuki RM 250
• 1996 Suzuki RM 125
• 1995 Suzuki RM 125
• 1994 Suzuki RM 125

RM22843-R00

Dimensions Stator :
Interior diameter: 28mm
Exterior diameter: 57mm
Thickness: 15mm
Length of wires stator to terminals: 600mm

Other specifications:
Number of wires: 4
Number of plugs: 0
Number of terminals: 4

Wire to wire resistance:
Source 1 : Red to White = 28 ohms +/-20%
Source 2 : Yellow to Yellow = 0.4 ohms +/- 20%

Dimensions Pickup Pulsar Coil:
Height: 25mm
Length: 22mm
Width: 18mm
Bracket center to center: 35mm
Wires length : 90mm

Other specifications:
Number of wires : 2
Number of pins: 2

Wire to wire resistance:
Pink/Red to White = 100ohms+/-20%

Before installing your new stator

• Solder RED wire from RM01293 stator to original BLACK/RED
• Solder WHITE wire from RM01293 stator to original WHITE/RED
• The two yellow wires for the RM01293 stator are provided for late model RM's that require a power valve supply. If your bike does not have these two wires, you have two options :

A) Simply cut the wires and insulate them so they cannot short out
B) Use it for a low wattage light. To do this, you must route the two yellow wires through the stator harness

Note : When bolting stator in always use locking compound.

Pickup Pulsar Coil :

• By using a small soldering iron weld the wires to the ones on your wiring harness.
• Insulate your solders with heat shrink.
• Before attempting to start your vehicle, adjusting the air gap is necessary for certain models.
• Rotate the fly wheel by hand so the raised node is lined up with the pick up /pulsar coil and adjust as close as possible, but no less than 0.010’’.
• If no spark or erratic spark, switch the wires at the plug.