Kit HO Stator + PeakRPM CDI + Coil + Cover Gasket for Yamaha YFM 660 Raptor 2002-2003

• 2003 Yamaha YFM 660 R Raptor
• 2002 Yamaha YFM 660 R Raptor

RM22832-R00

Dimensions Stator :
Interior diameter: 34 mm
Exterior diameter: 94 mm
Thickness: 13 mm

Other specifications:
Number of wires: 7
Number of plugs: 2
Number of pins: 7

Wire to wire resistance:
Alternator: White between each White = 0.4 ohms +/-20%
Pickup: Blue to Green = 450 ohms =+/-20%
Position Sensor: Black to Red = 0.1 ohms+/-20%

Dimensions CDI Box :
Height: 26mm
Length: 109mm
Width: 78mm
Distance between fixation holes: 125mm

Other specifications:
Number of plugs: 3
Number of pins: 18

Dimensions External Ignition Coil :
Distance between fixation holes: 60 mm

Before installing your new stator

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.

CDI Box
Our CDI may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.

External ignition coil Remove spark plug cap(s) from your OEM external ignition coil.
Screw cap(s) on the new external ignition coil.
Remove the yellow wire from external the ignition coil, if it is not applicable to your model.