Stator for Kawasaki Jet Ski 750 Super Sport XI / 750 SS / 750 ST / 750 STS / 750 STX / 750 ZX / 750 ZXI 1992-1998
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 1998 Kawasaki 750 STX
- 1997 Kawasaki 750 Super Sport XI
- 1997 Kawasaki 750 STS
- 1997 Kawasaki 750 SS
- 1996 Kawasaki 750 Super Sport XI
- 1996 Kawasaki 750 STS
- 1996 Kawasaki 750 SS
- 1995 Kawasaki 750 ZXi
- 1995 Kawasaki 750 Super Sport XI
- 1995 Kawasaki 750 STS
- 1995 Kawasaki 750 ST
- 1995 Kawasaki 750 SS
- 1994 Kawasaki 750Xi R
- 1994 Kawasaki 750 Super Sport XI
- 1994 Kawasaki 750 ST
- 1994 Kawasaki 750 SS
- 1993 Kawasaki 750 Super Sport XI
- 1993 Kawasaki 750 SS
- 1992 Kawasaki 750 SS
21003-3733
21003-3720
21003-3726
Dimensions :
Interior diameter : 42 mm
Exterior diameter : 104 mm
Thickness : 16 mm
Length of wires stator to grommet : 110 mm
Length of wires grommet to plug : 1600 mm
Length of pickup coil's wire to grommet : 90 mm
Other specifications :
Number of wires : 7
Number of plugs : 7
Number of pins : 7
Wire to wire resistance :
Alternator : Brown to Brown = 1.2 ohms +-20%
Pickup : Green to Blue = 522 ohms +-20%
Source : Red to Purple = 345 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- All products shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.