Generator Stator for Honda Scooter PS 125 125i 150 150i / SH 125 125i 150 150i 2005-2012
Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !
- 2012 Honda SH 125i
- 2012 Honda PS 125
- 2011 Honda SH 150i
- 2011 Honda SH 125i
- 2011 Honda PS 125
- 2010 Honda SH 150i
- 2010 Honda SH 125i
- 2010 Honda PS 150
- 2010 Honda PS 125
- 2009 Honda SH 150i
- 2009 Honda SH 125i
- 2009 Honda PS 150
- 2009 Honda PS 125
- 2008 Honda SH 150i
- 2008 Honda SH 125i
- 2008 Honda PS 150
- 2008 Honda PS 125
- 2007 Honda SH 150i
- 2007 Honda SH 125i
- 2007 Honda PS 150
- 2007 Honda PS 125
- 2006 Honda SH 150i
- 2006 Honda SH 125i
- 2006 Honda PS 150
- 2006 Honda PS 125
- 2005 Honda SH 150i
- 2005 Honda SH 125i
Dimensions :
Interior diameter : 35 mm
Exterior diameter : 95 mm
Thickness : 20 mm
Length of wires stator to grommet : 80 mm
Length of wires grommet to plug : 55 mm
Other specifications :
Number of wires : 3
Number of plugs : 1
Number of pins : 3
Wire to wire resistance :
Alternator : Between each yellow = 0.4 ohms +-20%
Before installing your new stator
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new aftermarket stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Connector included
- Rubber grommet included
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause for repetitive electrical issues.
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.