Menu

Worldwide USA & International Customer?  Go to International Store

X

Based on your location and your browser preferences, we suggest the following regional preferences:

English, Worldwide

Customer Service 1-877-838-1399 - 8AM-5PM EST Mon-Thu & 8AM-4PM EST Fri

Cart

0 item (CA$0.00)

X

You are currently searching with filters

Stator For Polaris RZR 4 900 XP RZR 900 XP EFI 2011 2012

RM01205
RMSTATOR

Stator For Polaris RZR 4 900 XP RZR 900 XP EFI 2011 2012

RM01205
RMSTATOR
Exact fit

Availability: In stock

Price: CA$259.00

OR

Brand new stator

  • You must re-install your original connector and grommet (see picture).
  • Once your connector and grommet is re-installed, our part becomes a plug-and-play unit, direct fit, and very easy to install.
  • Higher grade of electric components.
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • Grommet included
  • All products shipped are tested
  • One year limited warranty

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.


Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.


There are two possible stators for the RZR XP 900 and RZR 4 XP 900 models. This stator fits models built 3/15/12 and before (OEM# 4013224, stator thickness 27 mm). For the stator built 3/16/12 and after, the right part is RM01394 (OEM# 4013013, stator thickness 19 mm). Always check in the 'Fits models' section and please compare to your original part before buying.

Details

Brand new stator

  • You must re-install your original connector and grommet (see picture).
  • Once your connector and grommet is re-installed, our part becomes a plug-and-play unit, direct fit, and very easy to install.
  • Higher grade of electric components.
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • Grommet included
  • All products shipped are tested
  • One year limited warranty

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.


Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.


There are two possible stators for the RZR XP 900 and RZR 4 XP 900 models. This stator fits models built 3/15/12 and before (OEM# 4013224, stator thickness 27 mm). For the stator built 3/16/12 and after, the right part is RM01394 (OEM# 4013013, stator thickness 19 mm). Always check in the 'Fits models' section and please compare to your original part before buying.

Videos

Specifications

Dimensions :
Interior diameter : 53mm
Exterior diameter : 127mm
Thickness : 27mm
Length of wires stator to grommet : 80mm
Length of wires grommet to plug : 300mm

Other specifications :
Number of wires : 3
Number of plugs : 0
Number of pins : 3

Wire to wire resistance :
Alternator : White between each White = 0.4ohms +/-20%

OEM # Replacement

4013224

Fits models

Installation instructions

Before installing your new stator

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.

Reviews

Q&A