Menu

Worldwide USA & International Customer?  Go to International Store

X

Based on your location and your browser preferences, we suggest the following regional preferences:

English, Worldwide

Customer Service 1-877-838-1399 - 8AM-5PM EST Mon-Thu & 8AM-4PM EST Fri

Cart

0 item (CA$0.00)

X

You are currently searching with filters

USED-STATOR

RM01035U
RMSTATOR

USED-STATOR

RM01035U
RMSTATOR

Availability: Out of stock

Price: CA$92.00

  • Direct replacement to your original unit (Note: for some models you will need to reinstall one oem connector)
  • Plug-and-play, direct fit, easy installation.
  • Highest grade lamination materials
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • Pick up pulsar coils included
  • Connector included
  • Rubber grommet included
  • All product shipped are tested
  • There is a 30 day limited warranty and returns are NOT accepted.   

 

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Details

  • Direct replacement to your original unit (Note: for some models you will need to reinstall one oem connector)
  • Plug-and-play, direct fit, easy installation.
  • Highest grade lamination materials
  • Highest grade copper windings, resistant to 200 degrees Celsius.
  • Pick up pulsar coils included
  • Connector included
  • Rubber grommet included
  • All product shipped are tested
  • There is a 30 day limited warranty and returns are NOT accepted.   

 

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Videos

Specifications

Nine wires

Eight Terminals

ALTERNATOR White to White 0.9 ohms ±20%

ALTERNATOR White between Ground O.L. ON DISPLAY

PICKUP 1 Blue to Red 200 ohms ±20%

PICKPUP 2 Orange to White 200 ohms ±20%

SOURCE 1 Green to Brown 315 ohms ±20%

 

OEM # Replacement

1YW-85510-21-00
2NL-85510-20-00
2XK-85510-20-00

Installation instructions

Before installing your new stator

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator/rectifier
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors

 

Our stator may use a different wire color code then you’re original.

All of the wires are installed in the correct order; please do not change any of the wiring configurations.

This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound. Please install the pick up coil with the white dot on the top of the other one. Always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.

Reviews

Q&A