Voltage Regulator for Kawasaki KLT200 Duckster KLT250 Prairie / KZ250 CSR KZ440 KZ650 KZ750 LTD 1980-1985
Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 1985 Kawasaki KLT 250
- 1984 Kawasaki KLT 250
- 1984 Kawasaki KLT 200
- 1983 Kawasaki KZ 440 LTD
- 1983 Kawasaki KLT 250
- 1983 Kawasaki KLT 200
- 1982 Kawasaki KZ 750 CSR
- 1982 Kawasaki KZ 440 LTD
- 1982 Kawasaki KZ 250
- 1982 Kawasaki KLT 250
- 1982 Kawasaki KLT 200
- 1981 Kawasaki KZ 440 LTD
- 1981 Kawasaki KZ 250
- 1981 Kawasaki KLT 200
- 1980 Kawasaki KZ 750 LTD
- 1980 Kawasaki KZ 650
- 1980 Kawasaki KZ 440 LTD
- 1980 Kawasaki KZ 250
Dimensions:
Width: 62 mm
Length: 69 mm
Height: 25 mm
Wires length: 115 & 175 mm
Fixation holes center to center: 55 mm
Other specifications:
Number of plugs: 1
Number of pins: 5
Number of wires: 5
Minimum Charging Voltage: 14.5V +- 0.5V
Maximum Charging Current: 50A/500W
Open Circuit Voltage: 15V
Operation Temperature: -20° to 85°
Before installing your new voltage regulator rectifier:
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator rectifier.
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors.
Brand new aftermarket voltage regulator rectifier
- Direct replacement to your original unit.
- Plug-and-play, direct fit, easy installation.
- No assembly required
- Higher grade of electric components.
- The quality exceeds the OEM equipment
- All products shipped are tested
We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause for repetitive electrical issues.
All item pictures are accurate, if in doubt do not hesitate and compare our item to your original part.