High Output Performance Generator Stator 100 W / Adjustable Timing Backplate for Yamaha YFZ 350 Banshee 1995-2006
We offer as well two other stators for these models:
- Stator 100 W without a backplate : product RM01043
- Stator 200 W with a backplate and a regulator : product RM01034
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
- 2006 Yamaha YFZ 350 Banshee
- 2005 Yamaha YFZ 350 Banshee
- 2004 Yamaha YFZ 350 Banshee
- 2003 Yamaha YFZ 350 Banshee
- 2002 Yamaha YFZ 350 Banshee
- 2001 Yamaha YFZ 350 Banshee
- 2000 Yamaha YFZ 350 Banshee
- 1999 Yamaha YFZ 350 Banshee
- 1998 Yamaha YFZ 350 Banshee
- 1997 Yamaha YFZ 350 Banshee
- 1996 Yamaha YFZ 350 Banshee
- 1995 Yamaha YFZ 350 Banshee
3GG-85510-01-00
Interior diameter : 40mm
Exterior diameter : 103mm
Thickness : 17mm
Length of wires stator to grommet : 150mm
Length of wires grommet to plug : 330mm
Length of pickup coil's wire to grommet : 270mm
Other specifications :
Number of wires : 6
Number of plugs : 3
Number of pins : 3
Wire to wire resistance :
Alternator : = Yellow to Black = 0.4 ohms +/-20%
Pickup : White/Green to White/Red = 115 ohms +/-20%
Source : Green to Red = 22 ohms +/-20%
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
Brand new high output generator stator 100 watts with adjustable timing backplate
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- Rubber grommet included
- Adjustable timing plate to advance and retard up to 10 degrees included
- All product shipped are tested
20% MORE OUTPUT OVER STOCK, WORKS WITH ALL OTHER OEM COMPONENTS.
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.