0 item (CA$0.00)
Brand new generator stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- All products shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
Details
Brand new generator stator
- Direct replacement to your original unit
- Plug-and-play, direct fit, easy installation.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Pick up pulsar coil included
- Connector included
- All products shipped are tested
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
Videos
How Charging / Ignition / Starting Systems Work
How to repair your connectors like a pro!
RMSTATOR Corporate Video
Specifications
Dimensions:
Interior diameter: 40mm
Exterior diameter: 103mm
Thickness: 15mm
Length of wires stator to connectors: 300mm, 395mm
Length of pickup coil's wire to stator: 120mm
Other specifications:
Number of wires: 5
Number of plugs: 2
Number of pins: 5
Wire to wire resistance:
Alternator: = 0.4ohms +/-20%
Pickup: = 680 ohms =+/-20%
OEM # Replacement
Fits models
- Snowmobile
- 2017
- Ski-doo
- MX Z X-RS 600
- Ski-doo
- 2016
- Ski-doo
- MX Z X-RS 600
- Ski-doo
- 2015
- Ski-doo
- MX Z X-RS 600
- Ski-doo
- 2014
- Lynx
- Rave RS 600
- Ski-doo
- MX Z X-RS 600
- Lynx
- 2013
- Lynx
- Rave RS 600
- Ski-doo
- MX Z X-RS 600
- Lynx
- 2012
- Lynx
- Rave RS 600
- Ski-doo
- MX Z X-RS 600
- Lynx
- 2011
- Lynx
- Rave RS 600
- Ski-doo
- MX Z X-RS 600
- Lynx
- 2010
- Lynx
- Rave RS 600
- Ski-doo
- MX Z X-RS 600
- Lynx
- 2009
- Ski-doo
- MX Z 600 RS Carb L/C
- MX Z X-RS 600
- Ski-doo
- 2017
Installation instructions
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original. `
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010ââ.