0 item (CA$0.00)
Brand new generator stator
- You must re-install your original connector (see picture).
- Once your connector is re-installed, our part becomes a Plug-and-play unit, direct fit, and very easy to install.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Rubber grommet included
- All product shipped are tested
- One year limited warranty
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
Details
Brand new generator stator
- You must re-install your original connector (see picture).
- Once your connector is re-installed, our part becomes a Plug-and-play unit, direct fit, and very easy to install.
- Highest grade lamination materials
- Highest grade copper windings, resistant to 200 degrees Celsius.
- Rubber grommet included
- All product shipped are tested
- One year limited warranty
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
Videos
How Charging / Ignition / Starting Systems Work
How to repair your connectors like a pro!
RMSTATOR Corporate Video
Specifications
Interior diameter : 41mm
Exterior diameter : 106mm
Thickness : 14mm
Length of wires stator to grommet : 125mm
Length of wires grommet to plug : 225mm
Other specifications :
Number of wires : 3
Number of plugs : 0
Number of pins : 3
Wire to wire resistance :
Alternator : White between each White = 0.4ohms +/-20%
OEM # Replacement
Installation instructions
- Check the AC output of the stator.
- Replace any burned or corroded connectors on stator and regulator/rectifier
- Check and repair any melted wiring.
- Use hi-temp dielectric grease on all connectors
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".