Improved Magneto Flywheel Rotor
for Yamaha YZF-R1 / FZ1 / FZ8

Don’t wait for your rotor magnets to fall off!

Yamaha YZF-R1 bikes are well known for rotor failure. The original flywheel made by Yamaha uses low quality epoxy to secure the magnets to the rotor body. Over time and many heat cycles, the epoxy fails allowing the magnets to come loose and contact the stator, potentially causing catastrophic damage.

Fix and forget your YZF-R1 charging system problem with RMS Lab’s advanced technologies!

The new RMSTATOR heavy-duty flywheel rotor for Yamaha Motorcycles is a well-priced solution to problems with the OEM flywheel, and an excellent alternative to all the mechanical troubles you can encounter with a repair.

Watch our engineer explains how to change your flywheel.

OPTION 1

Improved Magneto Flywheel Rotor

  • Built to OEM size to fit precisely on your ride: install it and forget it
  • Uses high temperature epoxy that is stronger than OEM, eliminating the possibility of magnet detachment
  • Has a high grade steel capping to prevent heat and friction from degrading the epoxy attaching the magnets

OPTION 2

Generator with Improved Flywheel Upgrade

  • Meets & exceeds Yamaha's OEM specifications
  • Highest grade of lamination materials
  • Highest grade of copper winding, resistant to 200 degrees Celsius

OPTION 3

Improved Charging Systems Lithium-Ion Conversion Upgrade

  • Mosfet Voltage Regulator designed specifically for Lithium-Ion batteries
  • Regulator runs cooler than all SCR diode-style OEM regulators
  • Overheat protection: rather than burn up the regulator will simply turn off for a while and cool off
  • Plug & Ride Voltage Regulator Design with heavy-duty connectors

PLEASE NOTE : This voltage regulator is ONLY for lithium batteries

OPTION 4

Improved Charging System Upgrade

  • Complete charging system equiped with the latest technologies
  • Billet aluminum heatsink runs cooler by 33% than standard cast regulator housings
  • Overheat protection: rather than burn up the regulator will simply turn off for a while and cool off
  • Plug & Ride Voltage Regulator Design with heavy-duty connectors

RMS technologies included

Improved heavy duty epoxy

Our improved flywheel uses an high temperature epoxy that is stronger than OEM. It eliminates the possibility of magnets detachment.

High grade steel capping

To prevent heat and friction from degrading the epoxy attaching the magnets, our new flywheel has a high grade steep capping. Though extremely unlikely, if a magnet did ever come loose, it would remain in the sleeve preventing contact with the stator.

Plug & Ride voltage regulator design

Our voltage regulator rectifier housings for Yamaha YZF-R1 are manufactured to OEM specifications for a fast and easy installation.